Diagnostic and repair instructions for the "ERROR PIC control" problem

Come here to chat about mining topics not covered under Mining Pools, Mining Rigs, or Mining Algorithms.
Forum rules
The General Mining Topics forum is a place to discuss topics dealing with mining that don't fall into the categories of our other Mining Forums.

(For connectivity questions related to PROHASHING, please see Mining Rig and Connectivity Support.)

For the full list of PROHASHING forums rules, please visit https://prohashing.com/help/prohashing- ... rms-forums.
Post Reply
ZEUS MINING
Posts: 4
Joined: Tue Jul 26, 2022 3:58 am

Diagnostic and repair instructions for the "ERROR PIC control" problem

Post by ZEUS MINING » Mon Aug 01, 2022 4:16 am

The repair guide is for when the galvanic isolation has failed. This happens when more than 3.3volts comes from the hash board.
Before continuing with the following instructions, please ensure that your hash board and connection cable function correctly. Do not attempt to fix the tester if you’re not sure it is the cause of the problem!
Most of the time, the problem occurs because of the blown a fuse on the 3.3V power line. However, it may happen after connecting the hash board with a short in a power line.
You will need a fluke 17B+ multimeter for this repair. In addition, the hash board must be disconnected.
Set the multimeter to voltmeter mode. First, you must measure voltage between the is_GND and is_3V3 test points. Follow the images below.
Image
Image
The voltage must be around 3.3 volts. If the voltage on those points is ok, you need to proceed and check the F2 fuse.
Image
If the voltage on the F2 is lower than 3 volts - the isolated power supply is faulty. This repair is a bit more complicated and requires experience. In that case, please get in touch with a professional for repairs.
Image
Set the Fluke 17B+ multimeter to measure the resistance. Check the fuse like it’s shown in the picture below.
Image
If its resistance is 0 ohm - the fuse is working fine. In that case, the cause of the problem might be the I\O hash board connection cable, the connection port, hash board, or other components. For further instructions, please contact a professional for repairs.
Image
If F2 resistance is any other than 0 - the fuse is blown and needs to be replaced. Fuse is in 0402 case, 1 A. It can be purchased in most electronic stores. After replacing, ensure you solder it properly and perform all the measures again. After that, you can connect the hash board and check if the problem is fixed.
Image
Post Reply