When your Antminer's fault light is flashing red, you can restore it by restarting. There are two ways to restart the miner. The first is to turn off the miner, then turn it on again. The second is to click "Reboot" on the miner interface, as shown below: Miner Backstage> System> Reboot ht...

The repair guide is for when the galvanic isolation has failed. This happens when more than 3.3volts comes from the hash board. Before continuing with the following instructions, please ensure that your hash board and connection cable function correctly. Do not attempt to fix the tester if you’re no...

Antminer T9+ lost 2 hashboards after flashing Dollemizer firmware or building BMminer from source. Here is the solution: 1. Use the programmer to connect the T9+ hash board; pin 1 of the programming cableis in front of the PICKIT arrow; https://www.zeusbtc.com/Upload/image/202204/16508557867177580.j...

After the card is successfully swiped on the control board, the green indicator light is on. If there is only one indicator light on the control board when the power is turned on for the second time, please wait for 30s-60s before powering off, and then power on again, the control board will start n...